State SPX 50 DHPT Manual do Utilizador

1Hybrid ElectricHeat Pump Water HeaterInstallation Instructions and Use & Care GuideTo obtain technical, warranty or service assistance during or

10Water Heater Location □ Centrally located with the water piping system. □ The fl ooring beneath the water heater must be able to support the weight o

11OPERATING YOUR WATER HEATERBefore Using1. Make sure the water heater has been properly installed. See “Installing Your Water Heater” section.2.

12Adjusting the User Interface Module/Operational ModesWater Temperature AdjustmentThe water temperature can be adjusted from 95°F / 35°C to 140°F / 6

13Operational ConditionsWater OdorIn each water heater there is installed at least one anode rod (see parts sections) for corrosion protection of the

14ANODE ROD INSPECTIONEach water heater contains at least one anode rod, which will slowly deplete (due to electrolysis) prolonging the life of the wa

15MAINTENANCE OF YOUR WATER HEATERTemperature and PressureRelief ValveManually operate the temperature and pressure relief valve once a year to make

16ScrewsWiresElementFigure 15Screw-inElementFigure 16GasketSpudDraining and FlushingIt is recommended that the tank be drained and fl ushed every 6 mon

17DIAGNOSTIC CODES DISPLAY SHOWS INDICATES CORRECTIVE ACTIONEUC Upper element is not functioning 1. Turn off power at the circuit breaker/fuse box an

18TROUBLESHOOTING CHARTPROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTIONNO HOT WATER 1. No power to the water heater (No lights on the unit are on).2. Uni

19REPAIR PART ILLUSTRATIONITEMNO.PARTS DESCRIPTION1Element Access Cover2Element (4500 Watts)3Energy Cut-Off (ECO) Switch 4Temperature & Pressure R

2Your safety and the safety of others are very important.We have provided many important safety messages in this manual and on your appliance. Always

20500 Tennessee Waltz Parkway, Ashland City, TN 37015Technical Support: 800-365-0024 • Parts: 800-433-2545 • Fax: 800-644-9306www.statewaterheaters.co

3INSTALLING YOUR WATER HEATERConsumer InformationThis water heater should be installed in accordance with the local code authority having jurisdiction

4Figure 3Residential GarageInstallationVehicleStopDrain Drain Pan NOTE: The water heater shall be located so it is not subject to physical damage by m

5Water System PipingPiping, fi ttings, and valves should be installed according to the installation drawing (Figure 4). If the indoor installation area

6Please note the following: • The system should be installed only with piping that is suitable for potable (drinkable) water such as copper, CPVC, PE

7IMPORTANT: When making condensation connections to the primary connection DO NOT over tighten. Overtightening could crack or damage the condensate dr

8For protection against excessive pressures and temperatures, a temperature and pressure relief valve must be installed in the opening marked “T &

9If you lack the necessary skills required to properly install the electrical wiring to this water heater, do not proceed but have a qualifi ed electri